×
Menú
Fijaciones Marker

Marker Alpinist U-Bow

9,95 €
(5)
Zoom
Modelo: Medium
Medium
Disponible
Seleccionar
No gracias
Binding mounting
Si por favor
Productos relacionados
Binding mounting
Binding mounting (1 pieza)
Si por favor
17,95 €
Gratis
1 par
Cantidad
1 par
2 pares
3 pares
4 pares
5 pares
6 pares
7 pares
8 pares
9 pares
10+
Cantidad
1 par
2 pares
3 pares
4 pares
5 pares
6 pares
7 pares
8 pares
9 pares
Limited quantity available
Cantidad
1 par
2 pares
3 pares
4 pares
5 pares
Limited quantity available
  Guardar para luego
De la misma marca
Descripción

U-Bow Alpinist de Marker para fijaciones Alpinist pintech.

Una herramienta disponible en tres niveles de firmeza diferentes:

  • Blanda = aproximadamente 5.5DIN
  • Media = aproximadamente 8DIN
  • Dura = aproximadamente 11DIN
Reseñas   (5)
El envio del producto impecable. En cuanto al producto en sí , el montaje del producto en la fijación es bastante mas complicado de lo que parece. Ademas, el folleto de instrucciones no aclara este punto. Valoracion negativa para Marker
XAVIER MARTI IGUAL (RUBI)
21/01/2019
Evaluación: 1 de 5!
Respuesta de SkatePro:  Lamentamos su mala experiencia con el producto. Nos puede contactar para que le podamos aconsejar de cómo montarlo si todavía no lo hubiese conseguido :-) Un saludo / Soraya
Completely agree with Karol below. Nightmare to install. Had to file the inner edge a bit to get them on, after various failed attempts started to chew up the plastic/carbon body of the binding. The cut ends of the springs are pretty unrefined and could do with a bit of filing before they leave the factory. Once on, they work fine, I'm sure, and I got a swift and sensible reply from Skatepro when I asked for advice, so overall a positive experience. Would certainly use this retailer again.
Archie Gillies (Aberdeen)
12/11/2020
Evaluación: 4 de 5!
Have not had a chance to test them, not enough snow yet, but have no reason to believe they would not work. Got them to replace the "hard" DIN 12 bows that came with my bindings. They certainly were a bitch to install though. Not like the manufacturer describes it, just remove the small screw and slide it out/slide it in. The prongs are not quite parallel but rather convergent a bit. At the end I managed to spread them a little by forcing a suitable size of a socket wrench in between of them.
Karol S. (Northport)
28/10/2019
Evaluación: 4 de 5!
Mostrar todas las 5 reseñas
SkatePro