MENÚ
Atrás |

Dakine X Mat Stomp

EUR 7,95
Dakine

De vuestro interés

Zoom
Recibir un correo electrónico cuando un producto esté de nuevo disponible

Descripción

An accessory you install between your bindings on the snowboard, so your back foot does not slip.

This stomp is made from molded urethane. Therefor it is light weight and easy to work with.

For optimum bonding, make sure that both board and stomp are at room temperature, clean all surfaces with rubbing alcohol. When ready - Heat up the the prepared board surface with a hair dryer on the highest setting, along with the adhesive on the stomp. Immediately after heating - Place the stomp and press it down firmly. Stand on it without twisting about - The more weight the better. Allow the bond to cure at room temperature for 24 hours.

De vuestro interés

Reseñas

En este momento no hay ningún comentario.